KUHN AXIS 20.1, Operator'S Manual

Page: 113 / 216

Spreading Operation
101
B
AXIS
20.1
AXIS
20.1
B.10 Discharging residue
We recommend emptying the solid fertiliser broadcaster immediately after every
use to maintain its value. Proceed as with the calibration test to discharge the res-
idue. See
„Running calibration test“ on page 93 .
Instructions for completely discharging the residue:
Small amounts of fertiliser may remain in the solid fertiliser broadcaster when dis-
charging residue normally. If you wish to discharge the residue completely (e.g.
at the end of the season, when changing spreading material), please proceed as
follows:
1. Empty hopper until no more material comes out (normal residue discharge).
2. Turn off PTO shaft and tractor motor. Take out tractor ignition key.
3. With the metering slide open move the drop point back and forth (position 0
to 9 and back).
4. Remaining fertiliser can be removed with a soft water spray; see also „Clean-
ing“ on page 187 .
n
WARNING
Risk of injury from rotating machine components
Contact with rotating machine components (universal drive
shaft, hubs) may cause bruises, abrasions and crushing inju-
ries. Body parts or objects may be caught and pulled in.
 When the machine is running keep clear of the rotating
hubs.
 If the drive shaft is rotating, always engage the meter-
ing slide from the tractor cab only.
 Direct all persons out of the danger zone of the solid
fertiliser broadcaster
Set the drop point to 0 . Symbol:
Kg