Troubleshooting
17
Etching
Using too much detergent
Use less detergent if you have soft water
Lower the inlet water temperature
Problem
Dishwasher won't start
Dishwasher beeps at the end of
the cycle
Rinse Aid light on
Dishwasher operates too long
Dishes are not clean enough
Dishes not drying enough
Spots and filming on dishes
Possible cause
Power supply or power line is not connected
LED screen shows “Lsb”
The dishwasher is connected to cold water
Water pressure is temporarily low
Detergent dispenser is empty
Water hardness is too high
Dishwasher won't start
Child Lock activated
(selected models)
It indicates the wash cycle finished, the
dishwasher will beep
The cycle time will vary due to the soil
The sanitize option is selected
The inlet water temperature is low
Dishes are loaded too close together
improper use of detergent
The selected cycle is not suitable for food
soil condition
Spay arms is blocked by some items
Improper loading of dishes
The cycle you chose did not included the
drying
Improper loading of dishes
Old rinse aid is used
Rinse dispenser empty
Add rinse aid
Check the dishwasher, make sure it is properly
connected to the hot water supply
Fill rinse aid dispenser or increase the amount of
rinse aid.
For extremely hard water install a water softener
Deactivate the child lock, refer to child lock
section in this manual
When heavy soil is detected, the auto, normal,
pots&pan cycle will automatically increase the
cycle time
When sanitize option is selected, the cycle time
will be increase to meet the sanitized temperature
request
Load the dishes again as the manual
Add detergent depending on the water hardness
and the cycle you chose. Use fresh detergent
Make sure the dishwasher is connected to the hot
water supply
Try not use your dishwasher when hot water is
being used elsewhere in the house
Choose anther cycle for longer washing time
Make sure the spay arm is rotated freely
Load the dishes again as the manual instructs.
Choose the proper cycle with drying
Load the dishes again as the manual indicates
Use fresh rinse aid
Add rinse aid to the dispenser
Delay Start option has been selected
Check and connect the power supply
Shut the door completely make sure it is latched
Refer to Delay Start section in this manual to reset
Clean the door gasket
Use you dishwasher when the water pressure is
normal
Solution
The inlet water temperature exceeds 158
℉
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM