Kubota ZD1011-AU, Operator'S Manual

Page: 90 / 102

71 ADJUSTMENT
ADJUSTMENT
MOTION CONTROL LEVER
To avoid serious injury or death:
A
Park the machine on a firm and level surface.
A If it is necessary to run the engine in an
enclosed area, use a gas tight exhaust pipe
extension to remove the fumes.
A
Always try to work in a well-ventilated area.
A
Lift up and secure with jack stands or blocking
the rear of the machine, do not run the machine
while adjusting.
Remove rear wheels.
A
Do not adjust only one of the following
adjustments; exclude "MOTION CONTROL
LEVER ALIGNMENT".
They are interlinked.
A If you feel you are unable to make the following
adjustments correctly and safely, contact your
local KUBOTA Dealer.
A
Right and left motion control levers can be adjusted
independently.
B HST NEUTRAL
1. Lift up and secure with jack stands or blocking the rear
of the machine frame.
2. Remove both rear wheels.
3. Set the engine speed maximum.
4. Place the motion control lever in the "NEUTRAL
LOCK" position.
5. After forward and backward operation, tighten the
guide control at the position when wheel axis stops.
6. Adjust the rod length L of the damper 28 to 30 mm (1.1
to 1.2 in.) and tighten.
B
MAXIMUM SPEED (FORWARD)
Consult your local KUBOTA Dealer for this service.
(1) Guide control
(2) Motion control lever
(1) Damper (L) 28 to 30 mm (1.1 to 1.2 in.)