Kubota WSM L3560, Workshop Manual

Page: 800 / 801

CABIN
L3560, L4060, L4760, L5060, L5460, L6060, WSM
10-S57
Rear Wiper Motor
1. Remove the cover (1).
2. Disconnect the rear wiper motor
4P
connector.
3. Remove the wiper arm mounting nut (5) and wiper arm (6).
4. Remove the wiper link cap (4).
5. Remove the rear wiper motor mounting screws (2).
6. Remove the rear wiper motor (3).
(When reassembling)
• Attach the wiper arm (6) to the wiper motor (3) so that the
dimension
A
is 100 mm (3.94 in.) as shown in the figure.
9Y1210824CAS0097US0
[3] SERVICING
Adjustment of Air Gap
1. Measure the air gap with a feeler gauge.
2. When the measurement value comes off from factory
specification, adjustment shim (1) is added or deleted.
(Reference)
9Y1210824CAS0098US0
Tightening torque
Wiper arm mounting nut
6.4 to 9.3 N·m
0.65 to 0.95 kgf·m
4.7 to 6.8 lbf·ft
Rear wiper motor mounting
screw
4.9 to 6.9 N·m
0.50 to 0.70 kgf·m
2.6 to 5.1 lbf·ft
Distance
"A"
Factory specification
100 mm
3.94 in.
(1) Cover
(2) Wiper Motor Mounting Screw
(3) Rear Wiper Motor
(4) Wiper Link Cap
(5) Nut
(6) Wiper Arm
(7) Wiper Blade
Air gap (
L
) Factory specification
0.20 to 0.45 mm
0.0079 to 0.017 in.
Adjusting Shim Size Code No.
0.10 mm (0.0039 in.) T1065-87340
0.15 mm (0.0059 in.) T1065-87350
0.40 mm (0.016 in.) T1065-87360
0.60 mm (0.024 in.) T1065-87370
1.00 mm (0.0394 in.) T1065-87380
(1) Shim
L: Air Gap
KiSC issued 03, 2016 A