Kubota WSM L3560, Workshop Manual, Page: 793 / 801

CABIN
L3560, L4060, L4760, L5060, L5460, L6060, WSM
10-S50
(4) Removing Air Conditioner Pipes
Discharging Refrigerant Gas
• See page 10-S17.
9Y1210824CAS0079US0
Battery, Front Grill, Skirt and Bonnet
• See page 10-S35.
9Y1210824CAS0083US0
High Pressure Pipe 1
1. Disconnect the high pressure pipe 1 (2) from the compressor (1)
and condenser (3), then cap the open fittings immediately to
keep moisture out of the system.
(When reassembling)
• Apply compressor oil (DENSO ND-OIL 8 or equivalent) to the
O-rings and be careful not to damage them.
9Y1210824CAS0084US0
Hose Clamp
1. Remove the hose clamps (3) and harness cover (5).
2. Disconnect the high pressure pipe 2 (2) from the receiver (1)
and low pressure pipe (4) from the compressor, then cap the
open fittings immediately to keep moisture out of the system.
(When reassembling)
• Apply compressor oil (DENSO ND-OIL 8 or equivalent) to the
O-rings and be careful not to damage them.
9Y1210824CAS0085US0
Tightening torque
High pressure pipe 1
mounting screw
(Compressor side)
7.90 to 11.8 N·m
0.806 to 1.20 kgf·m
5.83 to 8.70 lbf·ft
High pressure side 1
retaining nut
(Condenser side)
4.0 to 6.8 N·m
0.41 to 0.69 kgf·m
3.0 to 5.0 lbf·ft
(1) Compressor
(2) High Pressure Pipe 1
(3) Condenser
Tightening torque
High pressure pipe 2
retaining nut
(Receiver side)
11.8 to 14.7 N·m
1.21 to 1.49 kgf·m
8.71 to 10.8 lbf·ft
Low pressure pipe
mounting screw
(Compressor side)
7.90 to 11.8 N·m
0.806 to 1.20 kgf·m
5.83 to 8.70 lbf·ft
(1) Receiver
(2) High Pressure Pipe 2
(3) Hose Clamp
(4) Low Pressure Pipe
(5) Harness Cover
KiSC issued 03, 2016 A