Assembly instruction
58
Assembly of the stirring
device and the sieve
For the spreading of powders and damp fertiliser types we advise the
fitting of an stirring device. The additional agitator movement improves
the flow to the dosing openings. The risk of blockages and bridge
formation in the hopper is reduced.
Always mount the sieve on top of the stirring device.
The sieve will prevent direct contact with the strongly moving stirring
device.
Leaving the sieve out can lead to serious injury.
Stirring device assembly
The points of the stirring device must be above the dosing openings.
Therefore the stirring device can only be placed on the agitator in one
way.
Place the stirring device with the largest hole over the widest arm
of the agitator.
Hook the lock clip in the middle behind the widest arm of the
agitator.
Let the stirring device drop over the other two arms of the agitator.
Press the points of the lock clip to the inside and then let the hooks
of the lock clip drop over the other two arms of the agitator.
Fit the sieve into the hopper after attaching the stirring device.
Lock clip
Agitator arm
Stirring device
