Kubota U50-5, Operating Instructions Manual

Page: 209 / 236

Maintenance
W9272-8135-1
207
05/2020
Battery - change

Open the side cover (page 155).

Remove the negative terminal cover and take off the cable
clamp (1). Move the clamp to the side so as to avoid contact
with the negative terminal.

Remove the positive terminal cover and take off the cable
clamp (3). Move the clamp to the side so as to avoid contact
with the positive terminal.

Remove the battery retainer (2) and lift the battery out of the
swivel frame.

Before installation, cover the battery terminals and cable clamps with petroleum jelly.

Install the battery in the swivel frame and fasten it with the battery retainer. Make sure that the battery is in-
stalled tightly
 Do not operate the machine with a loose battery.

Connect the positive cable clamp to the positive terminal (+) of the battery, install the positive terminal cover.

Connect the negative terminal (-) of the battery, install the negative terminal cover.
When disconnecting and connecting the battery, always observe the specified order  Risk of short
circuit.
When replacing the battery, always install a battery of
the same type with the same power rating and the
same dimensions.
Pre-installed battery
Type Hold-down Voltage
(V)
Capacity
(Ah)
Reserve Capacity
(Min.)
Cold Cranking Amps
(A)
Normal Charging Rate
(A)
90D26 L(JIS) B7 12 52 (5 h) 125 680 6.5
STOP
3 3
1 1
2 2