Kubota U35-4, Operator'S Manual, Page: 100 / 120

78 OTHER ADJUSTMENTS AND REPLACEMENTS
OTHER ADJUSTMENTS AND REPLACEMENTS
PURGING OF THE FUEL SYSTEM
1. Fill up the fuel tank with fuel.
2. Turn the starter key to the position "RUN".
3. The air in the fuel system will automatically be purged
within one minute.
A
If the purging was insufficient, the engine stops right
after starting. In this case repeat steps 2 to 3 again.
ADJUSTMENT OF TRACKS
C To loosen the tracks, follow the following
procedure:
To avoid personal injury or death:
A
Do not loosen the grease fitting completely or
too quickly. Otherwise grease under high
pressure in the tension cylinder could squirt
out.
A
Do not crawl under the excavator.
1. Loosen the bolts and remove the cover.
2. Using a socket wrench, loosen the grease fitting a few
turns.
3. When grease oozes out from the thread, rotate the
track and loosen the track in the lifted position (see
illustration).
After adjustment is completed:
Using the socket wrench, tighten the grease fitting.
Tightening torque must be between 98 to 108 N-m.
A If the tracks are too tight, wear is increased.
A
If the tracks are too loose, the track pads may collide
with the sprocket and wear is increased.
The track may dislocate or come off.
A
Clean the track after every use.
A
Should the track tension be high due to sticking mud,
lift the track with the help of the boom, arm and bucket,
idle the engine and remove mud from the track by
rotating it.
C
Tense the tracks as specified:
1. Loosen the bolt and remove the cover.
2. Apply grease to the grease fitting.
3. Rubber Tracks
Tense the track in the lifted position, so that the
distance "A" (clearance between the track roller and
the inside surface of the track) see illustration, in this
case, if there is a seam mark "
" on the inside
surface of the track, the seam mark " " is positioned
on the top center between the idler and the sprocket.
(1) Starter switch (A) "STOP"
(B) "RUN"
(C) "START"
(1) Cover
(2) Bolt
(3) Grease fitting
(4) Grease gun