Kubota RTV1140CPX, Workshop Manual

Page: 273 / 379

FRONT AXLE
RTV1140CPX, WSM
5-S15
(3) Front Differential Assembly
Front Differential Assembly
1. Remove the front differential case cover mounting screws and
separate the front differential case cover (1).
2. Remove the differential gear assembly (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1215E, Locktite 5699 or
equivalent) to joint face of the front case cover and front case
other eliminate the oil and stuck liquid gasket.
• Use same number of shims as before disassembling.
(Reference)
9Y1210293FAS0015US0
Bearings
1. Remove the right and left bearings (1) from the differential case.
9Y1210293FAS0016US0
Bevel Gear
1. Remove the bevel gear UBS screws (1).
2. Remove the bevel gear (2) from differential case (3).
(When reassembling)
• Apply liquid lock (Three Bond 1324B or its equivalent) to the
spiral bevel gear UBS screws.
9Y1210293FAS0017US0
Thickness of shim (RH)
(Case side)
Factory specification
0.50 mm
0.020 in.
Thickness of shim (LH)
(Cover side)
Factory specification
0.90 mm
0.035 in.
(1) Front Differential Case Cover
(2) Differential Gear Assembly (3) Front Differential Case
(1) Bearing
Tightening torque Bevel gear UBS screw
30 to 34 N·m
3.0 to 3.5 kgf·m
22 to 25 lbf·ft
(1) Bevel Gear UBS Screw
(2) Bevel Gear (3) Differential Case
KiSC issued 05, 2014 A