Kubota RTV1140 CPX, Operator'S Manual

Page: 73 / 104

51 PERIODIC SERVICE
B
Checking Parking Brake
Pull the parking brake lever to apply the brakes. With the
key switch at "ON" position, the parking brake indicator on
the instrument panel lights up. To release the brakes,
push in the button at the tip of the parking brake lever and
tilt down the lever.
A
Make sure the parking brake warning lamp on the
Easy Checker(TM) goes off when parking brake lever
is down.
B
Checking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM) lamps.
2. Replace if broken.
B
Checking Head Light, Turn Signal Light
etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
B
Checking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating vehicle.
2. Replace if damaged.
B
Checking Joint Boot
1. Check to see if the joint boots are not damaged.
2. If the boots are cut, cracked or shows signs of
deterioration, consult your local KUBOTA Dealer.
(1) Parking brake lever
(2) Release button (A) "PULL"
(B) "RELEASE"
(1) Joint boot
(2) Front drive shaft
(3) Tie rod
(1) Joint boot
(2) Rear drive shaft
(3) Grease nipple
(1) Joint boot
(2) Drive shaft