Kubota RTV-X900G, Operator'S Manual

Page: 105 / 126

83 PERIODIC SERVICE
ENGLISH
B Replacing Transmission Oil Filter [VHT]
To avoid serious injury:
A
Be sure to stop the engine before changing the
oil filter.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface. Disconnect the
trailer harness.
2. Disconnect trailer hitch.
3. Remove the rear guard.
4. Remove the oil filter.
5. Put a film of clean transmission oil on the rubber seal
of the new filter.
6. Quickly tighten the filter by hand until it contacts the
mounting surface, then, with a filter wrench, tighten it
an additional 1/2 turn only.
7. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
10. Install the rear guard.
11. Connect the trailer harness.
12. Properly dispose of used filter.
A
To prevent serious damage to the transmission, use
only a KUBOTA genuine filter.
B Replacing Transmission Oil Filter
[SUCTION]
To avoid serious injury:
A
Be sure to stop the engine before changing the
oil filter.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface. Disconnect the
trailer harness.
2. Disconnect trailer hitch.
3. Remove the rear guard.
4. Remove the oil filter.
5. Put a film of clean transmission oil on the rubber seal
of the new filter.
6. Quickly tighten the filter by hand until it contacts the
mounting surface, then, with a filter wrench, tighten it
an additional 1/2 turn only.
7. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
10.Install the rear guard.
11.Connect the trailer harness.
12.Properly dispose of used filter.
A
To prevent serious damage to the transmission, use
only a KUBOTA genuine filter.
(1) Transmission oil filter (VHT) (Yellow color)
(2) Rear guard
(3) Trailer harness
(1) Transmission oil filter (Suction) (Black color)
(2) Rear guard
(3) Trailer harness