(A) Press the inching and brake
pedal slightly
(B) Press the inching and brake
pedal all the way
Refilling
1. Press the inching-and-brake-pedal slightly to
approach the desired stop position.
2. Then press the inching-and-brake-pedal all the way
to stop the machine at the exact position.
• The traveling speed automatically decreases to
prevent the engine stalling as the external load
increases.
• During traveling with bucket operation, the
traveling speed abruptly increases at the time of
dumping operation since the external load
changes at that time.
3. Use the inching-and-brake-pedal and concentrate
the power to the attachment operation near holes or
slopes.
(A) Leave one pile
(B) Press the inching and brake
pedal slightly
(C) Press the inching and brake
pedal all the way
TYPICAL JOBS USING A
WHEEL LOADER
WARNING
To avoid personal injury or death:
• When transporting a load, keep the loader
bucket as low as possible to avoid tipping over.
Be extremely careful when working on inclines.
• Avoid unreasonable operation such as on
dangerous terrain, beyond the load capacity, or
beyond the intended use of the machine
because it may cause the machine to tip over.
• Slow down before entering ungraded terrain.
• Do not drive the machine close to the edges of
ditches or banks which may collapse under the
weight of the machine especially when the
ground is loose or wet.
• Operating on slopes in rain, in snow, at loose
gravel, at soft ground, and so on can be
dangerous because such situations will change
the ground conditions.
Do not operate this machine in questionable
ground conditions.
• Never perform digging or shoveling with the
machine in the articulated condition.
• Never dig or shovel at high speed.
Such operation can cause the machine to lose
balance and its rear wheels to lift off the
ground, which may cause a serious accident in
turn.
• To avoid possible tip over of machine, do not
operate the machine in any site whose terrain
cannot be ascertained, such as ground covered
with weeds or snow. Check for hidden
projections, dents, road shoulders, and so on,
beforehand, and take care not to approach them
during work.
• Be sure to ease up on the accelerator at the end
of backfilling grooves, the areas at the edge of
OPERATION OF THE MACHINE
TYPICAL JOBS USING A WHEEL LOADER
54
R430
Summary of Contents for R430
