Kubota M7131, Operator'S Manual

Page: 219 / 298

187 CAB OPERATION
WIPER
B
Front Wiper / Washer Switch
Turn on the key switch and turn the front wiper/washer
switch clockwise or anti-clockwise to activate the wiper.
When the front wiper/washer switch is pressed, washer
liquid jets out.
B
Rear Wiper / Washer Switch
Turn on the key switch and press the top half of the wiper
switch to the first stage, activating the wiper.
When the switch is pressed down to the second stage,
washer liquid jets out.
The jetting continues while the switch is pressed and the
wiper is activated continuously.
A
Do not activate the wipers when the windows are dry,
they may be scratched.
Be sure to jet washer liquid first and then activate the
wipers.
B
Using the Wipers in Cold Season
1. While not used in cold season, keep the wiper blades
off the windshield to prevent them from being stuck
with ice.
2. If the windshield is covered with snow, scrape it off the
windshield before using the wipers.
3. If the wiper blades are stuck on the windshield with ice
and fail to move, be sure to turn the main key switch to
"OFF" and remove the ice off the blades. Then place
the main key switch back to "ON".
4. When commercially available cold-season wiper
blades are used, make sure their size is the same as
or smaller than that of the standard ones.
A
In cold season, the wiper blades and the wiper motor
might get overloaded causing damage. To avoid this,
be sure to take the above precautions.
(1) Front wiper/washer switch (A) "OFF"
(B) "INTERMITTENT"
(C) "CONTINUOUS"
(D) "PUSH"
(1) Rear wiper/washer switch (A) "WIPER"
(B) "WIPER and WASHER"