Kubota M7-132, Operator'S Manual

Page: 299 / 332

3. Draw the element out of the cover and replace the
element with a new one.
NOTE :
• Even after stopping the engine, the injector
cooling DEF/AdBlue
®
fluid continues to
circulate through the circuit for a couple of
minutes.
When this circulation has ended, do the
replacement job. During cooling, the fluid’s
circulating noise is heard.
• Do not apply oil to the o-ring of the cover.
(1) Filter cover
(2) Element
(3) O-ring
EVERY 1 YEAR
1. Checking DPF differential
pressure sensor pipe
Consult your local KUBOTA Dealer for this service.
2. Checking EGR pipe
Consult your local KUBOTA Dealer for this service.
3. Checking oil separator hose
Consult your local KUBOTA Dealer for this service.
4. Checking anti-frost heater for oil
separator (if equipped)
Consult your local KUBOTA Dealer for this service.
5. Checking CAB isolation cushion
Check the cushion for any breakage or fatigue.
Replace them if they have deteriorated.
(1) CAB isolation cushion
EVERY 2 YEARS
1. Replacing DPF differential
pressure sensor hose
Consult your local KUBOTA Dealer for this service.
2. Replacing boost sensor hose
Consult your local KUBOTA Dealer for this service.
EVERY 3 YEARS
1. Replacing handbrake cable
Consult your local KUBOTA Dealer for this service.
EVERY 4 YEARS
1. Replacing radiator hose (water
pipes)
Replace the hoses and clamps.
(See Checking radiator hose and clamp on page 281.)
2. Replacing the fuel hose
Consult your local KUBOTA Dealer for this service.
3. Replacing intake air line
Consult your local KUBOTA Dealer for this service.
4. Replacing oil separator hose
Consult your local KUBOTA Dealer for this service.
5. Replacing the oil cooler line
Consult your local KUBOTA Dealer for this service.
EVERY 1 YEAR PERIODIC SERVICE
M7132, M7152, M7172
293