Kubota M7-132, Operator'S Manual

Page: 279 / 332

2. Adjusting toe-in
(A) Wheel-to-wheel distance at the rear
(B) Wheel-to-wheel distance at the front
(C) “FRONT”
Proper toe-in 0 to 8 mm
1. Park the tractor on a flat surface.
2. Turn the steering wheel so that the front wheels are
in the straight ahead position.
3. Lower the implement, lock the park brake and stop
the engine.
4. Measure the distance between the tyre beads at the
front of the tyre, at hub height.
5. Measure the distance between the tyre beads at the
rear of the tyre, at hub height.
6. The front distance should be shorter than the rear
distance. If not, adjust the tie rod length.
2.1 Adjusting toe-in procedure
1. Detach the snap ring.
2. Loosen the tie-rod nut.
3. Turn the tie-rod joint to adjust the rod length until
the proper toe-in measurement is obtained.
4. Retighten the tie-rod nut.
5. Attach the snap ring of the tie-rod joint.
(1) Snap ring
(2) Tie-rod nut
(3) Tie-rod joint
3. Cleaning inner air filter
Remove the inner filter, and blow air from the direction
opposite to the filter’s normal air flow.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm
2
, 30 psi).
When reassembling, adjust the 4 clasps to fix the filter
in it’s correct position.
(1) Inner air filter
4. Cleaning fresh air filter
WARNING
To avoid personal injury or death:
• When removing and attaching the filter, apply
the parking brake, stop the engine and remove
the key.
• Check the filter using a strong and stable ladder
to stand on.
Never check it while standing on a tyre or
fender.
1. Remove the knob bolts and pull out the filter.
EVERY 200 HOURS PERIODIC SERVICE
M7132, M7152, M7172
273