4. When connecting the battery cable, confirm the
cable and terminal plus and minus directions before
connecting.
(1) Battery cover
(2) Bolt
(3) Nut
IMPORTANT :
• After turning the key switch to “OFF” and
stopping the engine, the SCR system
automatically begins to cool off the system
and extract DEF/AdBlue
®
from the lines.
• Wait at least 15 minutes for the SCR system
to
complete
this
function
before
disconnecting the battery circuit for
inspection, repair, or long-term storage of
the battery or electrical components.
• Removing the battery before the completion
of this function may cause system errors or
damage to the system components.
• Even if the battery switch is turned to “OFF”,
the power supply will be sustained for about
15 minutes. Operating sound may continue
to be heard from the SCR system (for
example, from the DEF/AdBlue
®
tank or
DEF/AdBlue
®
pump) after stopping the
engine.
• This is the operating sound of the function
that is cooling the SCR system and
extracting DEF/AdBlue
®
from the lines, and
not an abnormal sound.
6. Checking front PTO oil (if
equipped)
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before checking the
front PTO oil.
1. Remove the filling plug and check to see if the oil
level is up to the plug hole. If low, add oil until it
flows out of the filling plug hole.
(See LUBRICANTS, FUEL AND COOLANT on
page 252.)
2. Tighten up the filling plug in place.
(1) Front PTO
(2) Filling plug
EVERY 200 HOURS
1. Draining fuel tank water
1. Unscrew the drain plug cover at the bottom of the
fuel tank.
2. Loosen the drain plug at the bottom of the fuel tank
to let sediments, impurities and water out of the
tank. Finally tighten up the plug.
(1) Fuel Tank
(2) Drain plug
(3) Plug cover
Tightening torque
Drain plug
19 to 21 N
⋅
m / 1.9 to 2.1 kgf
⋅
m / 14.0 to
15.5 ft
⋅
lbs
IMPORTANT :
• If the fuel contains impurities, such as water,
drain the fuel tank at shorter intervals.
• Drain the fuel tank before operating the tractor
after a long period of storage.
• The fuel tank is made of plastic. Be careful not
to overtighten the bolts.
PERIODIC SERVICE
EVERY 100 HOURS
272
M7132, M7152, M7172
Summary of Contents for M7-132
