Kubota M7-132, Operator'S Manual

Page: 267 / 332

(1) Parking/secondary brake
lever
(2) Release button
(A) “PULL”
(B) “RELEASE”
14. Checking gauges, meter and
Easy Checker
™
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker
™
indicators.
2. Replace if broken.
15. Checking headlight, direction
indicator light, hazard light, and so
on
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
16. Checking seat belt
1. Always check the condition of the seat belt
attaching hardware before operating the tractor.
2. Replace if damaged.
17. Checking movable parts
If any of the movable parts, such as levers and pedals,
are not moving smoothly because of rust or sticky
material, do not attempt to force them into motion.
In the above case, remove the rust or the sticky
material and apply oil or grease to the relevant spot.
Otherwise, the machine may be damaged.
INITIAL 5, 10, 25, AND 50
HOURS
With a new machine, be sure to do the following
servicing after the first 5, 10, 25 and 50 operating
hours.
1. Tightening bar axle torque
WARNING
To avoid personal injury or death:
• Never operate the tractor with loose wheel
bolts. Wheel bolts are critical and require
retightening.
1. Retighten the bolts after operating 5 hours, 10
hours, 25 hours, and 50 hours, as follows.
(1) 350 N ⋅ m / 35.7 kgf ⋅ m / 258 ft ⋅ lbs
INITIAL 50 HOURS
With a new machine, be sure to do the following
servicing after the first 50 operating hours.
1. Changing engine oil
(See Changing engine oil on page 277.)
2. Replacing engine oil filter
(See Replacing engine oil filter on page 277.)
3. Checking fan belt
(See Checking fan belt tension on page 274.)
4. Replacing transmission oil filter
(See Replacing transmission oil filter on page 287.)
EVERY 50 HOURS
1. Checking neutral circuit
WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
DAILY CHECK PERIODIC SERVICE
M7132, M7152, M7172
261