Kubota M7-132, Operator'S Manual

Page: 177 / 332

2. In travelling stop status, press the (F) or (R) switch
to move at a fixed speed while the switch is held
down. The speed will also increase if you step on
the foot throttle while travelling.
3. When switching travelling directions, press the (F)
or (R) switch after coming to a complete stop.
4. Step on the clutch pedal to stop.
NOTE :
• Depending on trouble spots, the tractor may fail
to run as expected.
• Park it in a safe place and immediately contact
your local KUBOTA Dealer.
• If you press the (F) or (R) switch by mistake,
turn the key switch off to leave limp home
mode.
Standard model
(1) Limp home switch forward (F)
(2) Limp home switch reverse (R)
Premium, Premium KVT model
(1) Limp home switch forward (F)
(2) Limp home switch reverse (R)
CONTINUOUSLY VARIABLE
TRANSMISSION (CVT)
CONTROL
WARNING
To avoid personal injury or death:
• The ez-command centre has no neutral
position. To bring the tractor to a complete
stop, step on the brake pedal or set the shuttle
lever to neutral.
The continuously variable transmission (CVT) is a fully
computerized stepless type. Depending on the type of
work, there are two modes to choose from:
“automatic”
and “manual engine speed setting”
Other settings are also possible at will, including CVT
sensitivity in response to engine load, response control
for start and stop, and cruise control among others.
(1) Ez-command centre
(2) Cruise button
(3) Ratio lock button
(4) Mode shift button (5) Shuttle neutral button
(6) Shuttle enable button
(7) Limp home switch
Travelling speed limit
When the left and right brake pedal interlock is
released, the travelling speed is limited to 40 km/h.
To cancel the travelling speed limit, stop the tractor and
interlock the left and right brake pedals.
1. Travelling operation
Travelling speed control for a tractor with CVT can be
operated with either the ez-command centre or the foot
throttle. Choose between them according to the job.
You can control both the speed and the engine power
by how deeply you step on the foot throttle, as with an
automatic transmission car; this enables convenient
operation of the trailer, etc.
NOTE :
• Operating the travelling speed control using the
foot throttle requires the selection of “automatic
mode”.
(See Cruise control on page 176.)
CONTINUOUSLY VARIABLE TRANSMISSION (CVT) CONTROL OPERATING THE TRACTOR
M7132, M7152, M7172
171