Kubota M6H-101, Operator'S Manual

Page: 173 / 202

4. After the new filter has been replaced, the engine
oil normally decreases by a small amount. Make
sure that the engine oil does not leak through the
seal and be sure to check the oil level on the
dipstick. Then replenish the engine oil up to the
prescribed level.
M6S-111 and M6H-101
(1) Engine oil filter
M6L-111
(1) Engine oil filter
IMPORTANT :
• To prevent serious damage to the engine,
use only a KUBOTA genuine filter.
3. Replacing fuel filter
1. Remove the fuel filter.
2. Put a film of clean fuel on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the
mounting surface.
Tighten the filter by hand an additional 1/2 turn only.
4. Bleed the fuel system.
(See Bleeding fuel system on page 181.)
M6S-111 and M6H-101
(1) Fuel filter
M6L-111
(1) Fuel filter
4. Replacing hydraulic oil filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before changing the
oil filter cartridge.
• Allow the engine to cool down sufficiently; oil
can be hot and can burn.
1. Remove the 2 oil filters.
2. Clean off metal filings with clean rags at the
magnetic filters.
3. Put a film of clean transmission oil on the rubber
seal of the new filters.
4. Tighten the filter quickly until it contacts the
mounting surface.
Tighten the filter by hand an additional 1/2 turn only.
EVERY 500 HOURS PERIODIC SERVICE
M6S-111,M6L-111,M6H-101
167