Kubota M6H-101, Operator'S Manual

Page: 131 / 202

3. Adjust the toe-in as 2 to 8 mm (0.1 to 0.3 in.).
(See Adjusting toe-in on page 162.)
IMPORTANT :
• Always attach wheels as shown in the
drawing.
• If not attached as illustrated, transmission
parts may be damaged.
• When re-fitting or adjusting a wheel, tighten
the bolts to the following torques then
recheck after driving the tractor 200 m (200
yards) and 10 times of shuttle movement by
5 m (5 yards), and thereafter according to
service interval.
(See MAINTENANCE on page 137.)
(1) 260 to 304 N ⋅ m / 26.5 to 31 kgf ⋅ m / 192 to 224 ft ⋅ lbs
NOTE :
• Wheels with beveled or tapered holes: Use
the tapered side of lug nut.
9.5-20
1530 mm
(60.2 in.)
--- ---
9.5-24 ---
1420 mm
(55.9 in.)
1520 mm
(59.8 in.)
(1) Tread
400/60-15.5
1890 mm
(74.4 in.)
(1) Tread
1.1 Front jack point
WARNING
To avoid personal injury or death:
• Before jacking up the tractor, park it on a firm
and level ground and chock the rear wheels.
• Fix the front axle to keep it from pivoting.
• Select jacks that withstand the machine weight
and set them up as follows.
(1) Jack point
WHEEL ADJUSTMENT TIRES, WHEELS, AND BALLAST (M6L-111)
M6S-111,M6L-111,M6H-101
125