Kubota M5-091, Operator'S Manual

Page: 84 / 176

PTO 60
B
LCD Monitor Message
1. The PTO rpm can be checked in the LCD monitor.
(See "LCD MONITOR" in "OPERATING THE
TRACTOR" section.)
2. When the PTO system gets engaged (ON), the
indicator lights up.
NOTE: [Interchangeable PTO (540/1000 rpm) model]
A
When the PTO speed is changed from 540 rpm to
1000 rpm, it is necessary to switch the PTO speed
display mode. Otherwise the PTO speed will not get
correctly displayed in the LCD monitor. Such mode
switching is also needed when returning to the 540
rpm PTO speed.
(See "LCD MONITOR" in "OPERATING THE
TRACTOR" section.)
B
PTO Shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft, be
sure engine is "OFF". Raise up the PTO shaft cover.
Afterward be sure to return the PTO shaft cover to the
"NORMAL POSITION".
A
The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
(1) LCD monitor
(2) PTO clutch indicator
(1) PTO shaft cover
(2) PTO shaft cap (A) "NORMAL POSITION "
(B) "RAISED POSITION "