Kubota M5-091, Operator'S Manual

Page: 127 / 176

103 PERIODIC SERVICE
EVERY 600 HOURS
B
Adjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
EVERY 1000 HOURS
B
Changing Transmission Fluid
To avoid personal injury or death:
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
4. After running the engine for a few minutes, stop it and
check the oil level again; add oil to prescribed level.
(1) Hose
(2) Hose clamps
(1) Adjusting screw
(2) Lock nut
Oil capacity 60 L (63.4 U.S.qts)
(1) Drain plug
(1) Dipstick
(2) Oil inlet (A) Oil level is acceptable within
this range.