Kubota L47TL, Operator'S Manual

Page: 52 / 159

OPERATING THE ENGINE 26
B
IntelliPanel(TM) Message
If you try to start the engine but the following messages
appear alternately in the display, the engine fails to start.
Follow the instructions shown on the display.
If the lamp is still on, immediately stop the engine and
determine the cause.
1. To set the rear parking brake, pull up the rear parking
brake lever.
2. To release the rear parking brake, push the release
button and push down the rear parking brake lever.
A
The rear parking brake indicator comes on while rear
parking brake is applied and goes off when it is
released.
8. Turn the key to "START" position and
release when the engine starts.
(1) Display
Disengage PTO
Set HST Pedal to Neutral
Turn the PTO clutch control
switch to "OFF" and foot off
of the speed control pedal.
Disengage PTO
Turn the PTO clutch control
switch to "OFF".
Set HST Pedal to Neutral
Foot off of the speed control
pedal.
9. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
Backhoe Operating Position
1. Make sure the rear parking brake is set.
(1) Rear parking brake lever
(1) Rear parking brake indicator
2. Make sure the fuel shut off-valve is in the
open position.
3. Place the PTO clutch control switch in
"OFF" position.
4. Set the throttle lever to about 1/2 way.