Kubota L47TL, Operator'S Manual

Page: 137 / 159

111 PERIODIC SERVICE OF THE TRACTOR
EVERY 400 HOURS
B
Cleaning Water Separator
This job should not be done in the field, but in a clean
place.
1. Disconnect the connector of water sensor.
2. Close the fuel shutoff-valve.
3. Unscrew the cup and remove it, then rinse the inside
with kerosene.
4. Take out the element and dip it in the kerosene to
rinse.
5. After cleaning, reassemble the water separator,
keeping out dust and dirt.
6. Connect the connector of water sensor.
7. Bleed the fuel system.
(See "SERVICE AS REQUIRED" in "PERIODIC
SERVICE" section.)
A If the water separator and/or fuel filter is not well
maintained, the supply pump and injector may be
damaged earlier than expected.
B Replacing Engine Oil Filter
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
A
To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(1) Water sensor connector
(2) Fuel shutoff-valve
(3) Cup (A) "CLOSE"
(1) O ring
(2) Element
(3) Element cup
(4) Red float
(5) Cup
(6) Drain plug
(7) Water sensor connector
(1) Engine oil filter