Kubota L4701, Operator'S Manual

Page: 77 / 142

• Tractor engine will not start if the PTO-clutch-
control-switch is in the “ON” position.
2. How to use the stationary PTO
To park the tractor and use the PTO system for chipper
or pump, for example, start the PTO system in the
procedure in this section.
1. Apply the parking brake and place blocks at the
tires.
(See To set the parking brake on page 35)
[Manual transmission type]
[HST type]
(1) Brake pedal
(2) Parking brake lever (A) Interlock the brake pedals
(B) Depress
(C) Pull
2. Make sure that all shift levers are in their
“NEUTRAL” positions.
3. Start the engine.
• [Manual transmission type]
See STARTING THE ENGINE [MANUAL
TRANSMISSION TYPE] on page 49.
• [HST type]
See STARTING THE ENGINE [HST TYPE] on
page 51.
4. Tilt the operator's seat forward.
5. Set the PTO-clutch-control-switch to engage
“ON” .
(1) Operator's seat
(2) PTO clutch control switch (A) Tilt forward
(B) Turn clockwise
(C) Off
(D) On
6. Set the engine speed to provide recommended rear
PTO speed.
NOTE :
• If the PTO system is engaged and you stand
up from the operator's seat or the operator's
seat is not tilted forward, the engine stops
automatically after standing up.
3. PTO shaft cover and PTO shaft
cap
Keep the PTO-shaft-cover in place at all times.
Replace the PTO-shaft-cap when the PTO shaft is not
in use.
When connecting or disconnecting the joint to the PTO
shaft, raise up the PTO-shaft-cover.
(1) PTO shaft cover
(2) PTO shaft cap (A) Normal position
(B) Raised position
IMPORTANT :
• The universal joint of the PTO-drive-shaft is
technically limited in its moving angle. Refer to
the PTO Drive Shaft Instructions for proper use.
PTO OPERATION POWER TAKE-OFF (PTO)
L4701
73