Kubota KGZ770-MA1, Operator'S Manual

Page: 108 / 117

STORAGE 88
ENGLISH
3. Drain the gasoline from the fuel filter bowl. Clean the
inside of the fuel filter bowl as necessary.
4. Reinstall the fuel filter bowl.
5. After that, turn the carburetor fuel valve to the "STOP"
(CLOSE) position.
A
Before adding fuel, make sure the carburetor fuel
valve is in the "STOP" (CLOSE) position and that the
drain plug is securely tightened. Turn the carburetor
fuel valve to the "RUN" (OPEN) position before
starting the engine.
B Inspecting and Cleaning Fuel Filter Bowl
Clean the fuel filter bowl before adding fuel to the engine.
To avoid serious injury or death:
A
Never smoke nor use fire or naked flame during
inspection or cleaning.
A Mixing of foreign matter or water in the fuel might
cause a plugged filter element prematurely or cause
much water to accumulate on the bottom of the fuel
filter bowl.
A If water accumulates on the bottom of the fuel filter
bowl, clean the fuel filter bowl or replace it with a new
one.
C
Inspecting and cleaning
1. Turn the carburetor fuel valve from the "RUN" (OPEN)
position to the "STOP" (CLOSE) position.
2. Loosen the ring screw and remove the fuel filter bowl.
3. Remove the filter element and wash it lightly by
dipping in gasoline. Replace any excessively
contaminated element with a new one.
(1) Carburetor fuel valve
(1) Carburetor fuel valve
(2) Drain port
(3) Fuel filter bowl (A) "STOP" (CLOSE)
(B) "RUN" (OPEN)
(C) "DRAIN"
(1) Carburetor fuel valve
(2) Ring screw
(3) Fuel filter bowl (A) "STOP" (CLOSE)
(B) "RUN" (OPEN)
(C) "DRAIN"