Kubota K008-5, Operating Instructions Manual

Page: 145 / 168

Maintenance
W9215-8135-1
143
06/2021
Battery - change

Open the engine hood (page 112).

Remove the negative terminal cover and take off the cable clamp. Move the clamp to the side so as to avoid
contact with the negative terminal.

Remove the positive terminal cover and take off the cable clamp. Move the clamp to the side so as to avoid
contact with the positive terminal.

Remove the battery retainer and lift the battery out of the swivel frame.

Before installation, cover the battery terminals and cable clamps with petroleum jelly.

Install the battery in the swivel frame and fasten it with the battery retainer. Make sure that the battery is in-
stalled tightly

Do not operate the excavator with a loose battery.

Connect the positive cable clamp to the positive terminal (+) of the battery, install the positive terminal cover.

Connect the negative terminal (-) of the battery, install the negative terminal cover.

Close the engine hood and secure it with a padlock.
When disconnecting and connecting the battery, always observe the specified order  Risk of short
circuit.
When replacing the battery, always install a battery of the same type with the same power rating and
the same dimensions.
STOP