Kubota G23, Workshop Manual

Page: 300 / 343

ELECTRICAL SYSTEM
G23, G26, WSM
6-S22 (EU)
Flasher Unit
1. Remove the under panel.
2. Disconnect the coupler (2) from flasher unit.
3. Measure the voltage with a voltmeter across the terminal
h
and
terminal
c
or chassis.
4. If the voltage differ from the battery voltage, the wiring harness
is faulty.
9Y1210294ELS0023US0
Flasher Unit Action Test
1. Set the hazard switch to the
ON
position, and make sure the
hazard light gives 60 to 85 flashes for a minute.
2. With the main switch and the hazard switch at the
ACC
and
ON
positions, respectively, move the turn signal light switch to the
left. Make sure that the right-hand light stays on and the
left-hand light gives flashes earlier (by about 20 flashes) than
when the hazard lamp is activated. Then move the turn signal
light switch to the right and make sure the corresponding
actions take place.
3. Now set the main switch to the
ACC
position and move the
blinker switch alone. Make sure the same actions as above
result.
4. If both the hazard switch and the turn signal light switch function
but the above actions do not take place, replace the flasher unit
with new one.
9Y1210294ELS0024US0
Voltage
Terminal
h
- Terminal
c
or Chassis
Approx. battery voltage
(1) Flasher Unit (2) Coupler
(1) Hazard Light Switch
(2) Turn Signal Light Switch (3) Flasher Unit
KiSC issued 08, 2009 A