25
REGULAR CHECKS AND MAINTENANCE WORK
EN
GLISH
[V2607-CR-TIE4, V3307-CR-TIE4]
[V3800-TIE4]
5. After the new cartridge has been replaced, the engine
oil level normally decreases a little. Thus, run the
engine for a while and check for oil leaks through the
seal before checking the engine oil level. Add oil if
necessary.
A
Wipe off any oil sticking to the machine completely.
B
Replacement of fuel filter cartridge
[V2607-CR-TIE4, V3307-CR-TIE4, V3800-TIE4]
1. Replace the fuel filter cartridge with a new one every
500 operating hours.
2. Apply fuel oil thinly over the gasket and tighten the
cartridge into position by hand-tightening only.
3. Finally, vent the air.
A
Replace the fuel filter cartridge periodically to prevent
wear of the supply pump or the injector, due to dirt in
the fuel.
A
The fuel filter cartridge and water separator should be
replaced earlier according to the fuel classification in
use.
B
Cleaning of water separator
(See “Draining of water separator” in “EVERY 50
SERVICE HOURS” in “REGULAR CHECKS AND
MAINTENANCE WORK” section.)
B
Removal of sediment in fuel tank
Consult your local KUBOTA Dealer for this service.
B
Cleaning of water jacket (radiator interior)
Consult your local KUBOTA Dealer for this service.
B
Replacement of fan belt
Consult your local KUBOTA Dealer for this service.
(See "Adjustment of fan belt tension" in "EVERY 100
SERVICE HOURS" or "EVERY 250 SERVICE HOURS"
in "REGULAR CHECKS AND MAINTENANCE WORK"
section.)
EVERY 800 SERVICE HOURS
B
Checking of valve clearance
[D1803-CR-TIE4, V2403-CR-TIE4]
Consult your local KUBOTA Dealer for this service.
EVERY 1000 SERVICE HOURS
B
Checking of valve clearance
[V2607-CR-TIE4, V3307-CR-TIE4, V3800-TIE4]
Consult your local KUBOTA Dealer for this service.
(1) Oil filter cartridge
(1) Oil filter cartridge
(2) Remove with a filter wrench (Tighten with your hand)
1J778-8915_E.book 25 ページ ２０１６年６月２０日 月曜日 午後５時７分
