15
OPERATING THE ENGINE
A
Daily checks with the Easy Checker(TM) only are not
sufficient. Never fail to conduct physical daily checks
carefully by referring to Daily Check section.
(See "DAILY CHECK" in "PERIODIC SERVICE OF
THE TRACTOR" section)
For the appropriate preheating time, refer to the table
below:
A
Glow plug indicator (4) comes on while engine is being
preheated.
A
Because of the safety devices, the engine will not start
except when the PTO clutch lever is placed in the
"OFF" position and speed control pedal is placed in the
"NEUTRAL" position.
C
Cold Weather Starting
When the ambient temperature is below -5
(23 ) and
the engine is very cold. If the engine fails to start, turn off
the key for 30 seconds. Then repeat steps
7
and
8
. To
protect the battery and the starter, make sure that the
starter is not continuously turned for more than 30
seconds.
B
Block Heater (Option)
A block heater is available as an option from your dealer.
It will assist you in starting your tractor when the ambient
temperature is below -15
(5 )
If a lamp is still on, immediately stop the engine and
determine the cause.
STOPPING THE ENGINE
A
If key does not stop the engine, consult your local
KUBOTA Dealer.
WARMING UP
To avoid personal injury:
A
Be sure to set the parking brake during warm-
up.
A
Be sure to set all shift levers to the "NEUTRAL"
positions and to place PTO clutch lever in
"OFF" position during warm-up.
For 5 minutes after engine start-up, allow engine to warm
up without applying any load, this is to allow oil to reach
every engine part. If load should be applied to the engine
without this warm-up period, trouble such as seizure,
breakage or premature wear may develop.
(1) Easy checker(TM)
(2) Engine oil pressure
(3) Electrical charge
(4) Glow plug indicator
7.
Turn the key to "PREHEAT" position
and hold it for about 2 to 3 seconds.
Temperature
Preheating Time
Over 0 C (32 F)
2 to 3 sec.
0 to -5 C (32 to 23 F)
5 sec.
-5 to -15 C (23 to 5 F)
10 sec.
8.
Turn the key to "START" position and
release when the engine starts.
9.
Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
1. After slowing the engine to idle, turn the
key to "OFF".
2. Remove the key.
