Kubota B2320, Operator'S Manual, Page: 45 / 88

29 PTO
PTO
PTO OPERATION
To avoid personal injury:
A
To prevent damage to PTO driven equipment
and possibly causing personal injury, use the
2nd rear PTO speed and mid-PTO speed only
when these higher rpms are specifically
recommended by the implement manufacturer.
To avoid personal injury:
A
Disengage PTO, stop engine, and allow all
rotating components to come to a complete
stop before connecting, disconnecting,
adjusting, or cleaning any PTO driven
equipment.
B
PTO Gear Shift Lever
The tractor has two rear PTO speeds and one mid PTO
speed.
To shift into 2nd PTO speed, loosen the bolt and slide the
restricting plate to (D) position.
A
Replace restricting plate to (C) position after use of the
2nd PTO speed.
A
To avoid shock loads to the PTO, reduce engine
speed when engaging the PTO, then open the throttle
to the recommended speed.
A
To avoid damage of transmission, do not shift PTO
gear shift lever until the PTO has stopped completely.
C
Mid PTO [Except B2320DTN]
The mid PTO is available for KUBOTA approved
implements.
C
Rear PTO speed
C
Mid PTO speed [Except B2320DTN]
A
There is a PTO-1 (540rpm) indicator mark on the
tachometer face. Be sure to check before operating.
A Tractor engine will not start if PTO gear shift lever is in
the engaged ("ON") position.
1st- Rear: 540 rpm
2nd- Rear: 960 rpm
Mid: 2500 rpm
(1) PTO gear shift lever
(2) Restricting plate
(3) Bolt (A) 1st (Rear: 540 rpm)
(B) 2nd (Rear: 960 rpm)
(Mid: 2500 rpm)
(C) Restricted position
(original position)
(D) Released position
(1) Mid PTO
Model Engine Speed rpm PTO Speed rpm Shaft
B2320
B2620
B2920
2773 540
6-Spline
2722 960
Model Engine Speed rpm
Mid-PTO Speed rpm
Shaft
B2320
B2620
B2920
2750 2500
10-Spline
USA
No.5