Kubota B1830, Workshop Manual

Page: 60 / 548

GENERAL B1830,B2230,B2530,B3030, WSM
G-35
Replacing Transmission Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filters.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Drain the transmission fluid.
2. Remove the both oil filter cartridges by using a filter wrench.
3. Apply a slight coat of oil onto the new cartridge gasket.
4. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
5. After the new cartridge has been replaced, the transmission
fluid level will normally decrease slightly. Make sure that the
transmission fluid does not leak through the seal. Check the
fluid level.
IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
9Y1210003GEG0037US0
Changing Front Axle Case Oil
1. Park the tractor on a firm, flat and level surface.
2. To drain the used oil, remove the right and left drain plugs and
filling plug at the front axle case and drain the oil completely into
the oil pan.
3. After draining, reinstall the drain plugs.
4. Fill with new oil up to the upper notch on the dipstick.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.
IMPORTANT
• After ten minutes, check the oil level again; add oil to
prescribed level.
5. After filling, reinstall the filling plug.
6. Properly dispose of used oil.
9Y1210003GEG0038US0
(1) Air Conditioner Condenser (2) Hydraulic Oil Filter Cartridge
Front axle case oil
capacity
B1830, B2230, B2530
3.7 L
3.9 U.S.qts
3.8 Imp.qts
B3030
4.7 L
5.0 U.S.qts
4.1 Imp.qts
(1) Filling Plug with Dipstick
(2) Drain Plug (A) Oil level is acceptable within this
range.
KiSC issued 05, 2012 A