Kubota B1830, Workshop Manual

Page: 55 / 548

GENERAL B1830,B2230,B2530,B3030, WSM
G-30
[5] CHECK POINTS OF EVERY 200 HOURS
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter cartridge with the filter wrench.
2. Apply a slight coat of oil onto the rubber seal of new filter.
3. To install the new cartridge, screw it in by hand an additional 1/2
turn only. Over tightening may cause deformation of rubber
gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
filter must be highly efficient. Use only a KUBOTA genuine
filter or its equivalent.
9Y1210003GEG0028US0
Checking Power Steering Line
1. Check to see that all lines and hose clamps are tight and not
damaged.
2. If hose and clamps are found worn or damaged,replace or
repair them at once.
9Y1210003GEG0086US0
(1) Engine Oil Filter Cartridge
(1) Power Steering Pressure Hose
KiSC issued 05, 2012 A