Kübler SMC1.3, Safety Manual

Page: 182 / 235

R60047.0002 - Index 2 EN – page 62 / 115
Continuation
„Runtime Test“:
Error code
SMCB
Error Message on PC
(Operator Software OS6.0)
Instruction
H‘ 1000 0000 Internal Error (ADC) Internal error
H‘ 2000 0000 Internal Error (I2C) Internal error
H‘ 4000 0000 Initialization Test Error
An initialization test error has been
detected
(see chapter “Initialization Test”)
With all error messages, the following applies:
Switch the unit OFF and ON again. If the error message continues,
please contact the manufacturer of the unit.
If a Poe error is triggered during the initialization phase, the activated
Power-up error will also trigger a run time error, regardless the cause
is still there. The deletion sequence can be found in the parameter
description under the parameter "Power-up error”.
11.4 Error Clearing
Error states can generally be cleared by switching power off and on again (after the
cause of the error has been removed). During commissioning only, errors can also be
cleared as described under chapter “Setup / Clearing Errors”. If a Poe error is triggered
during the initialization phase, the activated run time error is also raised, regardless the
cause is still there. The deletion sequence can be found in the parameter description
under the parameter "Power-up Error”