Kübler SMC1.3, Safety Manual

Page: 180 / 235

R60047.0002 - Index 2 EN – page 60 / 115
11.2 Initialization Test
These self-monitoring tests are processed automatically when switching the unit on.
Error code SMCB Error OS6.0 operator software Instruction
H‘ 0000 0001 ADC Error
Internal error
H‘ 0000 0002 I2C Error Internal error
H‘ 0000 0004 OTH Error Check the SMCB power supply or the
encoder supply or internal error
H‘ 0000 0008 SCI Error Internal error
H‘ 0000 0010 DIO Error Check the digital outputs for short
circuit resp. other errors or internal
error
H‘ 0000 0020 GPI Error Check the connections of the digital
inputs and the input configuration
or internal error
H‘ 0000 0040 CAP Error Internal error
H‘ 0000 0080 SPI Error Check the connections of the analog
output or internal error
H‘ 0000 0100 QEP Error Check the separation or disconnection
of the encoder supply at Self-Test
or internal error
H‘ 0000 0200 SCO Error Check splitter output or internal error
H‘ 0000 0400 CPU Error
Internal error
H‘ 0000 0800 RAM Error Internal error
H‘ 0000 1000 WDO Error Internal error
H‘ 0000 2000 EDM Error
Error in EDM Selftest, ceck connected
contactor or relay
H‘ 0000 4000 FLA Error Internal error
H‘ 0000 8000 PRG Error Internal error
H‘ 0001 0000 POE Error
Saved error active, error must be erased
before the device is re-connected.*
For all error messages, the following applies:
Switch the unit OFF and ON again.
If the error message continues, please contact the manufacturer of
the unit
.
If a Poe error is triggered during the initialization phase, the activated
Power-up error will also trigger a run time error, regardless the cause
is still there. The deletion sequence can be found in the parameter
description under the parameter "Power-up error”.