Kübler SMC1.3, Safety Manual

Page: 167 / 235

R60047.0002 - Index 2 EN – page 47 / 115
9 Setup
In order to ensure proper functionality, the parameters must be set appropriate values.
This section describes the most important parameters, which have to be set or checked
in either case.
9.1 Operational Mode Settings
The Parameters "Op-Mode 1" and Op-Mode 2 "are determined by the used encoder.
Notes on the encoder connection and the resulting "OP Modes" for Sensor 1 and sensor
2 can be read in the chapter Operating Modes SMC2.4 or SMC1.3.
No. Parameter Remark
016 „Op-Mode 1“ See chapter “Operating modes SMC2.4” or “Operating
modes SMC1.3”.
028 „Op-Mode 2“ See chapter “Operating modes SMC2.4” or “Operating
modes SMC1.3”.
At SMC1.3 "Op-Mode 2" must be set equal to "Op-Mode 1"!
9.2 Direction Settings
In order to define the directions, the machine must move resp. turn in its working
direction. As a first step,
must be selected from the button bar of the
operator screen.
The corresponding frequencies of Sensor 1 and Sensor 2 will then be indicated in the
Monitor field. In case of negative frequency values, the direction must be changed by
using the associated “Direction “ register in the parameter field of the corresponding
sensor menu.
No. Parameter Remark
018 „Direction 1“ Select direction of rotation
030 „Direction 2“ Select direction of rotation
At SMC1.3 " Direction 2" must be set equal to " Direction 1"!