Kübler Ants LES02, Operation Manual

Page: 34 / 160

3 Product Description Kübler Group
34 - EN BA Ants LES02 - R60073.0009 - 02
• The measured position is not evaluated. This requires a safe evaluation unit or control that
will be able to fulfill various position-dependent safety functions.
• In the event of an error, the measuring system sends no longer position data, but only error
codes. Therefore, the sending of a position within a certain time is not guaranteed. The ab-
sence of position data must be detected and evaluated by an external evaluation unit.
• The measuring system in no way actively intervenes in the elevator system. It is purely a pos-
ition sensor.
• The scope of the measuring system is not to measure lengths. Lengths vary in particular be-
cause of the temperature and other influencing factors.
3.4 Technical Data
NOTICE
Observe the configuration
The performance characteristics and the mechanical design of the
product depend on the selected configuration (according to order
code).
Extracts of the main technical data are listed below. All other characteristic values can be found
in the corresponding product data sheets.
3.4.1 Sensor
Mechanical characteristics sensor
Operating temperature -10 °C … +70 °C [14 °F … 158 °F]
Storage temperature -15 °C … +80 °C [5 °F … 176 °F]
Protection level according to EN 60529 IP54
Air humidity < 90 % (non-condensing)
Installation height < 2000 m [6562 ft]
Material Housing Aluminum
Weight appr. 0,55 kg [19.40 oz]
Maximum measuring length 392 m [1286 ft]
Maximum speed
certified
functional
8 m/s [26.25 ft/s]
12 m/s [39.37 ft/s]
Resolution
certified
functional
1 mm
[0.5 mm]
Accuracy ± 1 mm