Oil/water cooler PHE
(Plate heat exchanger)
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
41412 EN
4 of 7
2
Please observe protection
note ISO 16016.
Drawn:
2020-02-07 Pz/Bet
Replacing:
KTR-N dated 2017-08-16
Verified:
2020-03-03 Pz
Replaced by:
You may only assemble, operate and maintain the oil/water cooler if you
•
have carefully read through the operating/assembly instructions and understood them
•
are technically qualified and specifically trained (e. g. safety, environment, logistics)
•
are authorized by your company
The oil/water cooler may only be used in accordance with the technical data (see chapter 1). Unauthorized
modifications on the cooler are not admissible. We will not assume liability for any damage that may arise. In the
interest of further development we reserve the right for technical modifications.
The
oil/water coolers PHE
described in here correspond to the technical status at the time of printing of these
assembly/operating instructions.
The oil/water coolers are supplied in preserved condition and with painting and can be stored at a dry and roofed
place for 6 - 9 months.
!
The storage rooms must not include any ozone-generating devices like e. g. fluorescent
light sources, mercury-vapour lamps or electrical high-voltage appliances.
Humid storage rooms are not suitable.
Please make sure that condensation is not generated. The best relative air humidity is less
than 65 %.
!
In order to avoid any injuries and any kind of damage please always make use of proper
transport and lifting equipment.
The oil/water coolers are packed differently each depending on size, number and kind of transport. Unless
otherwise contractually agreed, packaging will follow the in-house packaging specifications of KTR.
2
Advice
2.4 Intended use
3
Storage, transport and packaging
3.1 Storage
3.2 Transport and packaging
