CLAMPEX
®
KTR 620
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40822 EN
6 of 11
9
Please observe protection
note ISO 16016.
Drawn:
2019-07-17 Wih/Jh
Replacing:
KTR-N dated 2017-05-17
Verified:
2019-07-18 Shg
Replaced by:
Tolerances, surfaces
Illustration 2:Tolerances and surfaces (example: CLAMPEX
®
KTR 620)
Tolerances for d
W
:
d
W
≤
Ø160=h6/H7
d
W
> Ø160=g6/H7
1) One proper turning process is
sufficient (Rz
≤ 16 µm).
2) Maximum permissible tolerance of
hub or shaft.
Please read through these operating/assembly instructions carefully before you mount the clamping set.
Please pay special attention to the safety instructions!
The operating/assembly instructions are part of your product. Please store them carefully and close to the clamp-
ing set. The copyright for these operating/assembly instructions remains with KTR.
Warning of potentially explosive
atmospheres
This symbol indicates notes which may contribute to pre-
venting bodily injuries or serious bodily injuries that may
result in death caused by explosion.
STOP
Warning of personal injury
This symbol indicates notes which may contribute to pre-
venting bodily injuries or serious bodily injuries that may
result in death.
!
Warning of product damages
This symbol indicates notes which may contribute to pre-
venting material or machine damage.
General advice
This symbol indicates notes which may contribute to pre-
venting adverse results or conditions.
STOP
With assembly and disassembly of the clamping set it has to be made sure that the entire
drive train is secured against accidental switch-on. You may be seriously hurt by rotating
parts. Please make absolutely sure to read through and observe the following safety indica-
tions.
•
All operations on and with the clamping set have to be performed taking into account "safety first".
•
Please make sure to switch off the power pack before you perform your work on the clamping set.
•
Secure the power pack against accidental switch-on, e. g. by providing warning signs at the place of switch-on
or removing the fuse for current supply.
•
Do not reach into the operation area of the machine as long as it is in operation.
•
Please secure the rotating drive components against accidental contact. Please provide for the necessary
protection devices and covers.
1
Technical data
2
Advice
2.1 General advice
2.2 General hazard warnings
