KTM Freeride E-XC 2018, Owner'S Manual

Page: 56 / 146

12 SERVICE WORK ON THE CHASSIS
54
12.6 Installing the fork legs
C00800-10
Main work
–
Position the fork legs.
Bleeder screws 1 face forwards.
Info
The lowest milled groove in the fork leg must be flush
with the top edge of the upper triple clamp.
The support for the brake caliper is attached to the left
fork leg.
C00798-11
–
Tighten screws
2
.
Guideline
Screw, top triple
clamp M8 22 Nm (16.2 lbf ft)
–
Tighten screws
3
.
Guideline
Screw, bottom triple
clamp M8 18 Nm (13.3 lbf ft)
C00799-10
–
Position the brake caliper. Mount and tighten screws 4 with
the spacers.
Guideline
Screw, front
brake caliper M8 25 Nm (18.4 lbf ft)
Loctite
®
243™
–
Position the brake line, wiring harness, and clamp. Mount and
tighten screws
5
.
–
Connect the plug-in connector of the speedometer sensor and
mount the cable tie(s).
Finishing work
–
Install the front wheel. ( p. 86)
–
Refit the headlight mask with the headlight. ( p. 96)
–
Install the KTM PowerPack. ( p. 103)
–
Lock the seat. ( p. 63)
–
Check the headlight setting. ( p. 99)
12.7 Removing the fork protector
Preparatory work
–
Deactivate the vehicle. ( p. 37)
–
Fold the seat up. ( p. 63)
–
Remove the KTM PowerPack. ( p. 102)
–
Mount the covering cap. ( p. 65)