16 KTM POWERPACK, BATTERY CHARGER
108
C00769-10
–
Switch on the battery charger using switch
3
.
Charging starts automatically. The status indicator flashes
during the charging process.
C00770-10
–
Monitor the charging level of the KTM PowerPack using the
LEDs.
LED 1: 20%
LED 2: 40 %
LED 3: 60 %
LED 4: 80 %
LED 5 flashes beginning with approx. 95% until 100% is
reached.
Once the charging process is complete, all five LEDs light up
and the status indicator goes out.
C00769-11
–
Switch off the battery charger using switch
4
.
After several seconds, all LEDs on the battery charger go
out.
–
Disconnect the battery charger power plug from the mains con-
nection.
–
Disconnect the charging cable from the KTM PowerPack.
Guideline
Pull on the structured part of the connector. Do not pull on
the cable.
–
Check the seal on the charging socket protection cap.
» If the seal is dirty:
–
Clean the seal without using water or compressed air.
» If the seal is damaged or worn:
–
Change the seal.
–
Mount the charging socket protection cap.
Finishing work
–
Lock the seat. (
16.7
Charging the KTM PowerPack in the Storage charging mode
Note
Material damage
The power supply will be damaged in the event of an overload.
In the
Storage
charging mode, a steady current of at least 10 A is required.
–
Ensure that the mains connection can supply the steady current required and is protected by a suitable fuse.
Summary of Contents for Freeride E-XC 2018
Page 1: ...OWNER S MANUAL 2018 Freeride E XC Art no 3213653en...
Page 2: ......
