KTM Freeride 350, Owner'S Manual

Page: 88 / 113

SERVICE WORK ON THE ENGINE
86
» If the engine oil is not up to the middle
A
of the level viewer:
–
Add engine oil. ( p. 87)
16.3
Changing the engine oil and oil filter, cleaning the oil screen
x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preliminary work
–
Park the motorcycle on a level surface.
–
Remove the engine guard. ( p. 58)
B01125-10
Main work
–
Place a suitable container under the engine.
–
Remove the oil drain plug
1
with the magnet and seal ring.
Info
Do not remove screws
A
on both sides.
B01126-10
–
Remove plug
2
with oil screen
3
and the O-rings.
B01128-10
–
Remove screws
4
. Remove the oil filter cover with the O-ring.
B01129-10
–
Pull oil filter
5
out of the oil filter housing.
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.