KTM Freeride 350, Owner'S Manual

Page: 74 / 113

ELECTRICAL SYSTEM
72
13.1
Removing the battery
x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
B01102-10
–
Switch off all power consumers and switch off the engine.
–
Remove screw
1
.
–
Take off fastening plate
2
.
B01103-10
–
Take the battery out of the battery compartment.
–
Disconnect negative cable
3
of the battery.
–
Pull back the positive terminal cover
4
and disconnect the positive (plus) cable of
the battery.
13.2
Installing the battery
x
B01104-10
–
Connect the positive cable.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
–
Attach negative cable.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Battery (YTX4L-BS) ( p. 98)
Info
Contact disk
A
must be mounted between screw
1
and cable socket
2
with the claws facing down.
–
Slide positive terminal cover
3
over the positive terminal.