KTM Freeride 350 2013, Owner'S Manual

Page: 81 / 113

15 ELECTRICAL SYSTEM
79
602813-10
Main work
–
Turn rubber cap
1
together with the underlying bulb socket counterclockwise all
the way and remove it.
–
Pull bulb socket
2
of the parking light out of the reflector.
100862-10
–
Press headlight bulb
3
lightly into the bulb socket, turn it counterclockwise, and
pull it out.
–
Insert the new headlight bulb.
Headlight (S2/socket BA20d) ( p. 100)
–
Insert the rubber cap with the bulb socket into the reflector and turn it clockwise
all the way.
Info
Ensure that O-ring
4
is seated properly.
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Refit the headlight mask with the headlight. ( p. 78)
–
Check the headlight setting. ( p. 80)
15.9 Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
800137-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
1
.
–
Lightly squeeze orange cap
2
in the area of the holding lugs and take it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W/socket BA15s) ( p. 100)
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.