18
SERVICE WORK ON THE ENGINE
89
B01671-10
Main work
–
Remove the gear oil drain plug with magnet
.
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug with magnet
and seal ring.
Guideline
Gear oil drain plug with magnet
M12x1.5
20 Nm
(14.8 lbf ft)
18.5
Filling in gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
B01670-11
Main work
–
Remove filler plug
and fill up with gear oil.
Gear oil
0.80 l (0.85 qt.)
Engine oil (15W/50) (
–
Mount and tighten the oil filler plug.
Danger
Danger of poisoning
Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
18.6
Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
The gear oil level should only be added when the engine is cold.
Preparatory work
–
Park the motorcycle on a level surface.
B01669-10
Main work
–
Remove the gear oil monitoring screw
.
B01670-10
–
Remove filler plug
.
–
Fill in gear oil until it emerges from the drilled hole of the gear oil monitoring
screw.
Engine oil (15W/50) (
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check
M6
10 Nm (7.4 lbf ft)
