7
HANDLEBAR, CONTROLS
32
7.1
Handlebar position
0
0
B01035-10
On the upper triple clamp, there are two holes at a distance of
A
to each other.
Hole distance
A
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance of
B
from the center.
Hole distance
B
3.5 mm (0.138 in)
The handlebar supports can be mounted in four different positions.
7.2
Adjusting the handlebar position
Warning
Danger of accidents
Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
0
0
B01036-10
–
Remove screws
1
. Remove the handlebar clamps. Take off the handlebar and lay it
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
2
. Take off the handlebar supports.
–
Move the handlebar supports into the desired position. Mount and tighten
screws
2
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
1
and tighten evenly.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
7.3
Adjusting the basic position of the clutch lever
B01710-10
–
Adjust the basic position of the clutch lever to your hand size by turning adjusting
screw
1
.
Info
When the adjusting screw is turned clockwise, the clutch lever moves away
from the handlebar.
When the adjusting screw is turned counterclockwise, the clutch lever
moves closer to the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply force.
Do not make any adjustments while riding!
