KTM Freeride 250 R AUS 2014, Repair Manual

Page: 179 / 222

26 CLEANING, CARE
177
26.1 Cleaning the motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors,
cables, bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component.
Excessive pressure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
401061-01
–
Close off the exhaust system to keep water from entering.
–
First remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a
paintbrush.
Motorcycle cleaner ( p. 204)
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water
first.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the plug from the exhaust system.
–
Clean the alternator. ( p. 168)
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake
system.
–
Clean or dry a dirty or wet brake system by riding and braking gently.
–
After cleaning, ride a short distance until the engine reaches operating tempera-
ture.
Info
The heat produced causes water at inaccessible locations in the engine and
the brake system to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. ( p. 77)
–
Treat bare metal parts (except for the brake discs and exhaust system) with anti-
corrosion materials.
Preserving materials for paints, metal and rubber ( p. 205)
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
uct.
Special cleaner for glossy and matte paint finishes, metal and plastic surfaces
( p. 205)