18
30/ENGINE
125
202789-10
–
Carefully mount the water pump shaft
3
.
Info
Watch out for the shaft seal ring.
202788-10
–
Mount water pump impeller
2
.
–
Mount and tighten screw
1
.
Guideline
Screw, water pump wheel
M5
6 Nm
(4.4 lbf ft)
Loctite
®
243™
18.4.14 Checking the clutch
309385-10
–
Check the clutch push rod
1
for damage and wear.
» If there is damage or wear:
–
Change the clutch push rod.
–
Place the clutch push rod
2
on a flat surface and check for run-out.
» If there is run-out:
–
Change the clutch push rod.
–
Check the length of clutch springs
3
.
Clutch spring - length
≥
38.0 mm (
≥
1.496 in)
» If the clutch spring length is shorter than specified:
–
Change all clutch springs.
–
Check the contact surface of pressure cap
4
for damage and wear.
» If there is damage or wear:
–
Change the pressure cap.
–
Check the thrust surfaces of the clutch facing discs in clutch basket
5
for wear.
Contact surface of clutch facing discs in outer clutch hub
≤
0.5 mm (
≤
0.02 in)
