KTM Freeride 250 F 2018, Owner'S Manual

Page: 111 / 157

ELECTRICAL SYSTEM 15
109
E00360-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser 1 .
–
Lightly squeeze together the orange cap
2
in the area of the
holding lugs and take it off.
–
Press the turn signal bulb carefully into the socket, turn it
counterclockwise by about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it
free from grease.
–
Press the new turn signal bulb carefully into the socket and
turn it clockwise until it stops.
Turn signal (R10W/socket BA15s) ( p. 140)
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it
engages in the thread. Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
15.10 Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically at a distance
A
away from the
wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with driver.
» If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. ( p. 110)