KTM F8203R2, Owner'S Manual

Page: 142 / 174

18 SERVICE WORK ON THE ENGINE
140
K00572-10
–
Pull oil filter
6
out of the oil filter housing.
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
K00573-10
–
Lay the motorcycle on its right side and fill the oil filter hous-
ing approx.
⅓
full with engine oil.
–
Place the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
7
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover M6 10 Nm (7.4 lbf ft)
–
Stand the motorcycle upright.
401955-12
–
Remove filler plug
8
from the clutch cover together with the
O-ring, and fill up with engine oil.
Engine oil 1.0 l
(1.1 qt.) Engine oil
(SAE 10W/50)
(
p. 161)
Engine oil
Alternative engine
oil for harsh operat-
ing conditions and
increased performance Engine oil
(SAE 10W/60)
(00062010035)
(
p. 160)
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
–
Start the engine and check that it is oil-tight.
Finishing work
(EXC
‑
F AU, EXC
‑
F Six Days)
–
Install the engine guard. ( p. 95)
–
Check the engine oil level. ( p. 138)